&Fluorocarbon paint product introduction:
& A two-component solvent-based exterior wall paint made of high-quality fluorocarbon resin, additives and metallic pigments. It has excellent weather resistance and stain resistance. properties, chemical resistance (acid, alkali, salt, etc.), and the service life can reach more than 10 years.
Product features: Strong UV resistance, excellent weather resistance, excellent stain resistance and corrosion resistance, strong construction properties, and excellent decorative properties.
Product use: It can be used as a decorative protective coating for building exterior walls, steel structures, roads and bridges, wooden structures, etc.
Technical parameters:
Gloss: degree + (degree) Full cure: days (degrees Celsius)
Theoretical paint consumption: /
Drying time: surface dry & hour (degrees Celsius) flash Point: approx Celsius.
Drying time: hours (degrees Celsius)
Packaging and storage:
Specifications: /
Store in a cool, dry place, away from fire sources, sealed at room temperature and can be stored for several months.
1. Base layer treatment
Inspect the entire base surface of the exterior wall point by point, and mark and treat the areas that are falling off, loose and hollow.
Remove all loose and hollow parts of the original base surface to eliminate potential safety hazards. Then use the cracking treatment system to carry out substrate treatment according to the actual conditions of the substrate.
After partial repair is completed, wash the entire surface with water to remove dust, oil stains and attachments. Use fluorocarbon paint thinner to clean
oil stains and attachments that are firmly attached.
Use ~#emery cloth to polish and texture the surface to increase its surface roughness and enhance its interlayer bonding force.
Coating of diepoxy sealing primer
After the base layer has been cured and the moisture content is no more than %, mix the two-component epoxy sealing primer in the specified proportion, stir evenly and spray it on the treated base layer It plays the role of resisting alkali and increasing the bonding force between layers. When spraying, it should be applied from top to bottom, from left to right, and it must be evenly applied, especially at the yin and yang corners.
Fluorocarbon paint metal fluorocarbon undertakes fluorocarbon paint project fluorocarbon paint contracting materials